Formation, Transformation, and Electrical Performance of Magnéli Phases Obtained by Flame Spraying from TiO2 Particles
ABSTRACT: In this paper, the formation and transformation of Magne ́li phases (TinO2n-1) during manufacturing of flame-sprayed coatings from two powders consisting of anatase nanoparticles and submicrometric particles with Magne ́li phases is analyzed, respectively. These powders were thermally spra...
- Autores:
-
Vargas Galvis, Fabio
Holguín Villa, Juan David
Arias Gómez, Jhoman Alberto
Mejía Roldán, Andrés Felipe
Velásquez, Álvaro Andrés
Arroyave, Mauricio
Palacio Espinosa, Claudia Constanza
- Tipo de recurso:
- Article of investigation
- Fecha de publicación:
- 2024
- Institución:
- Universidad de Antioquia
- Repositorio:
- Repositorio UdeA
- Idioma:
- eng
- OAI Identifier:
- oai:bibliotecadigital.udea.edu.co:10495/38584
- Acceso en línea:
- https://hdl.handle.net/10495/38584
- Palabra clave:
- Dióxido de titanio
Titanium dioxide
Revestimientos protectores
Protective coatings
Revestimientos céramicos
Ceramic coating
Proceso de pulverización con llama
Flame spraying process
http://id.loc.gov/authorities/subjects/sh85135627
- Rights
- openAccess
- License
- http://creativecommons.org/licenses/by/2.5/co/
| Summary: | ABSTRACT: In this paper, the formation and transformation of Magne ́li phases (TinO2n-1) during manufacturing of flame-sprayed coatings from two powders consisting of anatase nanoparticles and submicrometric particles with Magne ́li phases is analyzed, respectively. These powders were thermally sprayed on a ceramic substrate through oxidizing and neutral flame. Crystalline phases in powders and coatings were identified by x- ray diffraction and quantified by the Rietveld method, verifying the presence of identified crystalline phases in coatings by x-ray photoelectron spectroscopy. Finally, the electrical conductance of coatings was measured by the four-point probe method. Results indicate that Magne ́li phases are produced from anatase nanoparticles sprayed using both the oxidizing and neutral flames, and when the neutral flame and finest particles are used, a high quantity of Ti4O7 and Ti5O9, recognized thanks to their high electrical conductivity, is obtained. In contrast, when the coatings were fabricated from the powder containing Magne ́li phases, they were oxidized as much in oxidizing as in neutral flame, producing a partial transformation from Ti4O7 and Ti5O9 to both the rutile phase and TiO in low quantity. In spite of this partial transformation, the coatings maintain high electrical conductivity thanks to Ti4O7 and Ti5O9 Magne ́li phases remaining and the TiO produced. |
|---|
