Non-fundamental effective apparent power defined through an instantaneous power approach
ABSTRACT: This paper proposes a new definition of non-fundamental effective apparent power based on an analysis of instantaneous power flows. This new instantaneous power approach for the calculation of the non-fundamental effective apparent power extends, and adapts for new electrical conditions, t...
- Autores:
-
Muñoz Galeano, Nicolás
Alfonso Gil, José Carlos
Orts Grau, Salvador
Seguí Chilet, Salvador
Gimeno Sales, Francisco José
- Tipo de recurso:
- Article of investigation
- Fecha de publicación:
- 2011
- Institución:
- Universidad de Antioquia
- Repositorio:
- Repositorio UdeA
- Idioma:
- eng
- OAI Identifier:
- oai:bibliotecadigital.udea.edu.co:10495/41304
- Acceso en línea:
- https://hdl.handle.net/10495/41304
- Palabra clave:
- Energy resources
Recursos energéticos
Energía eléctrica
Electric power
IEEE Std. 1459
http://vocabularies.unesco.org/thesaurus/concept212
- Rights
- openAccess
- License
- http://creativecommons.org/licenses/by-nc-nd/2.5/co/
| Summary: | ABSTRACT: This paper proposes a new definition of non-fundamental effective apparent power based on an analysis of instantaneous power flows. This new instantaneous power approach for the calculation of the non-fundamental effective apparent power extends, and adapts for new electrical conditions, the procedure applied by IEEE Std. 1459 for the quantification of active and reactive power in single-phase systems. This proposed approach is based on the analysis of per-phase and three-phase instantaneous power flows when a three-phase four-wire balanced non-linear load is connected to an ideal power network that supplies a set of positive-sequence fundamental voltages. The per-phase and three-phase instantaneous power flows caused by positive-, negative-, and zero-sequence harmonic load currents are analyzed. The results obtained for the load zero-sequence harmonic currents disagree with the results obtained when applying IEEE Std. 1459. As a consequence, a new definition of the effective quantities is proposed. A comparison between the new definitions and IEEE Std. 1459 definitions is made in the paper. |
|---|
