Ultrahigh strain-rate bending of copper nanopillars with laser-generated shock waves

ABSTRACT: An experimental study to bend FIB-prepared cantilevered single crystal Cu nanopillars of several hundred nanometers in diameter and length at ultrahigh strain rate is presented. The deformation is induced by laser-generated stress waves, resulting in local strain rates exceeding 107 s 1. L...

Full description

Autores:
Colorado Lopera, Henry Alonso
Ming Yang, Jenn
Prikhodko, Sergey V.
Navarro, A.
Gupta, Vijai
Ghoniem, N.
Tipo de recurso:
Article of investigation
Fecha de publicación:
2013
Institución:
Universidad de Antioquia
Repositorio:
Repositorio UdeA
Idioma:
eng
OAI Identifier:
oai:bibliotecadigital.udea.edu.co:10495/38464
Acceso en línea:
https://hdl.handle.net/10495/38464
Palabra clave:
Focused ion beams
Transmission electron microscopy
Microscopía Electrónica de Rastreo
Microscopy, Electron, Scanning
Nanoestructuras
Nanostructures
Dinámica molecular
Molecular dynamics
Ondas de choque
Shock waves
Cristalografía
Crystallography
Metales de transición
Transition metals
http://id.loc.gov/authorities/subjects/sh2004007286
http://id.loc.gov/authorities/subjects/sh93001918
https://id.nlm.nih.gov/mesh/D008855
https://id.nlm.nih.gov/mesh/D049329
Rights
openAccess
License
http://creativecommons.org/licenses/by-nc-nd/2.5/co/
Description
Summary:ABSTRACT: An experimental study to bend FIB-prepared cantilevered single crystal Cu nanopillars of several hundred nanometers in diameter and length at ultrahigh strain rate is presented. The deformation is induced by laser-generated stress waves, resulting in local strain rates exceeding 107 s 1. Loading of nano-scale Cu structures at these extremely short loading times shows unique deformation characteristics. At a nominal stress value of 297 MPa, TEM examination along with selected area electron diffraction characterization revealed that twins within the unshocked Cu pillars interacted with dislocations that nucleated from free surfaces of the pillars to form new subgrain boundaries. MD simulation results were found to be consistent with the very low values of the stress required for dislocation activation and nucleation because of the extremely high surface area to volume ratio of the nanopillars. Specifically, simulations show that the stress required to nucleate dislocations at these ultrahigh strain rates is about one order of magnitude smaller than typical values required for homogeneous nucleation of dislocation loops in bulk copper single crystals under quasi-static conditions.